小金井低速雙活塞桿式氣缸,日本KOGANEI氣缸[產品打印頁面]

]資料

小金井低速雙活塞桿式氣缸,日本KOGANEI氣缸的詳細介紹

小金井低速雙活塞桿式氣缸,日本KOGANEI氣缸
The average speed is obtained by dividing the stroke by the time
??Suitable for low speed transfer of fragile workpieces.
??Cylinder’s outer dimensions are the same as
the standard product.
3. Air used for the cylinder should be clean air that contains no
deteriorated compressor oil, etc. Install an air filter (filtration
of a minimum 40 μm) near the cylinder or valve to remove
collected liquid or dust. In addition, drain the air filter
periodically.
Collected liquid or dust entering the cylinder may cause
improper operation.
??Enable stable operation from 1mm/s [0.04in./sec.].Note
??Smooth operation without stick-slips.
??Wide range of cylinders are available:
6 types and 10 bore sizes.
??Speed controllers for low speed cylinders
required to travel the stroke. The above average speed values
were obtained by tests undertaken at Koganei. They do not imply
guaranteed values of the product.
The speed value reads positive when the cylinder is extended.
1mm/s = 0.03944in./sec. 1mm = 0.0394in.
Always thoroughly blow off (use compressed air) the tubing
before piping. Entering metal chips, sealing tape, rust, etc.,
generated during piping work could result in air leaks or other
defective operation.Except the items listed below, all outer dimensions,
cylinder specifications, sensor switch specifications,
2. Use air for the media. For the use of any other media, consultus.

產品留言

標題

聯系人

聯系電話

內容

驗證碼

點擊換一張

注：1.可以使用快捷鍵Alt+S或Ctrl+Enter發送信息!
2.如有必要,請您留下您的詳細聯系方式!